Warning message after converting project of v4.5 to v5.0
2 posters
Page 1 of 1
Warning message after converting project of v4.5 to v5.0
Dear Sir/Madam:
After upgrading VisualDSP++ from v4.5 to v5.0 with Update 3, I converted my project that was built with v4.5 to v5.0, every time after building, there was a warning message something like
Trying to load an executable built for 0.0 silicon to a 0.1 silicon target. Continue? Yes (button) or No (button)
Even though it is not a big deal but do you know how to eliminate that message? Thanks a lot.
After upgrading VisualDSP++ from v4.5 to v5.0 with Update 3, I converted my project that was built with v4.5 to v5.0, every time after building, there was a warning message something like
Trying to load an executable built for 0.0 silicon to a 0.1 silicon target. Continue? Yes (button) or No (button)
Even though it is not a big deal but do you know how to eliminate that message? Thanks a lot.
Last edited by GoldenMaple on Mon Aug 25, 2008 10:12 am; edited 1 time in total
GoldenMaple- Posts : 11
Join date : 2008-08-22
Re: Warning message after converting project of v4.5 to v5.0
Under Project->Project Options can you please make sure that the "Revision" setting is 0.1? Or you can set the revision to automatic. The error message indicates that 0.0 silicon revision has been currently chosen. By changing the "revision" to 0.1 should stop this message appearing.
Please reply if it helps.
Please reply if it helps.
Last edited by lzmind on Fri Aug 22, 2008 7:28 pm; edited 1 time in total
lzmind- Posts : 18
Join date : 2008-08-20
Re: Warning message after converting project of v4.5 to v5.0
Thanks for your support. That worked.
Interestingly, however, the revision selection was automatic. After I selected 0.1 for dsp revision, the warning message was eliminated. Then I changed it to automatic again, the message did not appear any more. I bet that the revision was reset to 0.0 after converting, and the selection was not reflected in Project Option window.
It was good to discuss issues with professionals like you, lzmind. Thanks.
Interestingly, however, the revision selection was automatic. After I selected 0.1 for dsp revision, the warning message was eliminated. Then I changed it to automatic again, the message did not appear any more. I bet that the revision was reset to 0.0 after converting, and the selection was not reflected in Project Option window.
It was good to discuss issues with professionals like you, lzmind. Thanks.
GoldenMaple- Posts : 11
Join date : 2008-08-22
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum